Instruction manual

14
OPERATING GUIDELINES
6. Reworking task can be started as soon as the desired hot air
temperature and airflow l evel are reached, as also indicated from
displaypanels“11”and“12”,respectively.
7. When reworking is complete, return the Hot Air Gun to its holder
andDONOTimmediatelyturnoffthemainpowerswitch.
8. DeactivatetheHotAirGunActivationbuttonfirstinordertoactivate
theautocoolingprocess.Thesystemwillstarttoblowair(atroom
temperature)atafastratetoreduceheatfromthehot airgunand
bring down the temperature to a reasonable safe level of 90°C.
During this time, the prefix of the display for hot air gun
temperature will also change from “A” to “E” while temperatureis
graduallydecreasing.Likewise,theairpressurelevelisatitshighest
readingasindicated fromthe displaypanel.Oncethetemperature
dropstoapproximately90°C thesystemwill haltanddisplay“OFF”
on the panel. Itis now safe toswitch off themain power switch.
Seeillustrationbelow.
9. TurnOFFthemainpowerswitch.
10. Unplugthedevicefromthemainpowersource.
NOTES:
1. HotAirGunTemperatureisadjustablebetween100°
and480°Cwithanincrementof10°oneachstep.
2. HotAirGunAirflowRateisadjustablebetween6and
99withanincrementof3oneachstep.
15
OPERATING GUIDELINES
3. Connect the vacuum tube to the Smoke Absorber Terminal or
VacuumCap(“7”fromthecontrolpanel).
4. IMPORTANT: SettheBLOWERorVACUUMACTIVATIONswitchto
“VacuumAir”.
5. Activate the “SOLDER IRON” Activation switch (“17” from control
panel).This will automatically starttoincreasethetemperatureof
thesolderingironto350°C(default).
NOTE: Ahighbeepsoundwillbeheardwhenthedefaulttemperature
(orwhenthedesiredtemperature)isreached.
6. AdjustthesolderingirontemperatureusingtheSOLDER/DESOLDER
TEMPERATUREADJUSTMENTbuttons(“4”fromthecontrolpanel).
7. Activate the “SMOKE ABSORBER” Activation switch (“16” from the
controlpanel).
8. Start using the soldering iron as soon as desired temperature is
reached.
9. Whenthetaskisfinished,deactivatetheSMOKEABSORBERswitch.
10. DeactivatetheSOLDERIRONactivationswitch.
11. SettheBLOWER/VACUUMACTIVATIONswitchbackto“BlowAir”.
12. Detach the soldering iron connection assembly from the 6pin
receptacleatthecontrolpanelaswellasthevacuumtubefromthe
vacuumcap(ifnecessary).
13. Allow sufficient time for the soldering iron to cool down before
keepinginasafestorage.(Optionalbutrecommended)
C. SOLDERING IRON
1. Connect the Soldering Iron connection assembly to the 6pin
receptacle located at the front of the control panel (“8” from the
CONTROLPANELGUIDE).
IMPORTANTNOTE: Steps3,4,7,9,and11areoptionalwhenusingonlythe
solderingiron.Ifthesmokeabsorberfunctionwillbe
used,theseproceduresarerequired.