Instruction manual

16
NOTE: The soldering iron and desoldering gun operating
temperatureisconfigurablebetween200°Cand480°C.
D. DESOLDERING GUN
1. Connect the Desoldering Gun connection assembly to the 6pin
receptacle at the front of the control panel (“8” from CONTROL
PANELGUIDE).
2. Followtheinitialprocedures(“A.INITIALPROCEDURES”).
3. Connect the vacuum tube to the Smoke Absorber Terminal or
VacuumCap(“7”fromthecontrolpanel).
4. IMPORTANT: SettheBLOWERorVACUUMACTIVATIONswitchto
“VacuumAir”.
5. Activate the “SOLDER IRON” Activation switch (“17” from control
panel).This will automatically starttoincreasethetemperatureof
thedesolderinggunto350°C(default).
NOTE: Thesystemwillproduceahighbeepsoundwhenthedefault
temperature(orwhenthedesiredtemperature)isreached.
6. Adjust the desoldering gun temp. using the SOLDER/DESOLDER
TEMPERATUREADJUSTMENTbuttons(“4”fromthecontrolpanel).
7. You may start using the desoldering gun when the desired
temperature is reached. Use the trigger of the desoldering gun to
pickupunnecessarysolderleads.
8. Whenthetaskisfinished,deactivatetheSOLDERIRONswitch.
9. SettheBLOWER/VACUUMACTIVATIONswitchbackto“BlowAir”.
10. Detach the desoldering gun connection assembly from the 6pin
receptacleatthecontrolpanelaswellasthevacuumtubefromthe
vacuumcap(ifnecessary).
11. Allow sufficient time for the desoldering gun to cool down before
keepinginasafestorage.(Optionalbutrecommended)
IMPORTANT: Makesure the SMOKEABSORBER switch is
deactivated while using the desoldering gun. Otherwise,
thedesolderinggunwillkeeponsuckingairindefinitely.
OPERATING GUIDELINES
13
OPERATING GUIDELINES
4. Adjust the air flow level using the AIR PRESSURE ADJUSTMENT
BUTTONS(“3”fromthecontrolpanel).Theprefixofthedisplayfor
AirPressurewillchangefrom“F”to“E”whileairflowlevelisbeing
adjusted.Itwillreturnto“F”assoonasthedesiredlevelisreached.
Inthecasebelow,thefinalairflowlevelis“F89”.
IMPORTANT: Whenadjustingtheairtemperature,itisstrongly
advised toinitially increase the airflowlevel inorder to manage
the system temperature. This is to protect the heating element
insidethehandlefromexcessiveheatandavoidthepossibilityof
subjectingadjacentcomponentstothermalshock.
DefaultSystemParameters(HotAirGun)
5. Adjust the hot air gun air temperature using the HOT AIR GUN
TEMPERATURE ADJUSTMENT BUTTONS (“2” from the control
panel). The prefix of the display for Hot Air Gun Temperature will
change from “A” to “b” indicating that air temperature is being
adjusted. It will return to “A” while the temperature is gradually
increasingordecreasinguntilthedesiredtemperatureisreached.In
theexamplebelow,finalairguntemperatureis“A380”.