Instruction manual

18
CONTROL PANEL GUIDE
NOTE:Theautosleepfeatureisautomaticallydeactivatedwhen
thedeviceisswitchedOFForwhentheRESETbuttonis
pressedwithoutdoingtheproceduresspecifiedabove.
F. Activating Soldering Iron & Desoldering Gun Auto-Sleep Mode
Asidefromtheautostandbymodefeatureofthehotairgun,the
device has a separate mechanism to put the soldering iron or
desolderinggunintoSLE EP modeafteracertainperiod.Bydefault,this
is deactivated and the user must do any of the following two sets of
procedures(whicheverisapplicable)inordertoactivatethisfeature.
CONDITION1: DeviceisinitiallyswitchedOFF(mainpowerswitchOFF)
1. Makesureallfunctionswitchesaredeactivated.
2. TurnONthemainpowerswitch.
3. Hold both UP and DOWN buttons of the SOLDER/DESOLDER
TEMPERATUREAdjustmentbuttons.
4. ActivatetheSOLDERIRONswitchwhilestillholdingboththeUP
andDOWNbuttonsfromthepreviousstep.
5. Make sure the following was momentarily shown from the
solderingi ron/desolderingguntemperaturedisplaypanel(“13”
fromthecontrolpanel).
6. Releasethetwobuttonstoputthe
deviceintooperation.
CONDITION2: DeviceisalreadyswitchedON
1. Hold both UP and DOWN buttons of the SOLDER/DESOLDER
TEMPERATUREAdjustmentbuttons.
2. PresstheRESET buttononcewhilestillholdingthetwo buttons
fromthepreviousstep.
3. Makesurethesamedisplayabovewasmomentarilyshownfrom
thesolderingiron/desolderingguntemperaturedisplaypanel.
4. Releasethetwobuttonstoputthedevicebackintooperation.
11
IMPORTANTREMINDERS:
1. Make sure the equipment is placed on a flat stable surface
and al l the heatgenerating components placed on their
respectiveholdersorstands.
2. E nsureallfunctionswitchesareOFFpriortoreworking.
3. E nsureallterminalconnectionsareproperlysecured.
HowtousetheRESETbutton?
The RESET button (“15” from the control panel) is used to
reconfiguretemperatureandairflowlevelsettings.I n very rarecases,
thismayalsosolvesomeminordisplayoroperationissues(seeBASIC
TROUBLESHOOTING GUIDE for further details). When pressed, the
systemwill temporarilyswitchtostandbymode thenstartthedevice
using factory default operating parameters (provided the respective
functionswitchisactivated):
HotAirGunTemperature: 100
o
C
HotAirGunAirflowLevel: 51
SolderingIronTemperature: 350
o
C
IMPORTANT: PleaserefertotheCONTROL PANEL GUIDE
pageforbuttonsanddisplaypaneldirectory.
HowtousetheCAL(calibration)utility?
Inspecial cases,itmaybenecessarytosynchronizetheamountof
heat delivered by the soldering iron with an external temperature
sensing device. This can be achieved by slowly tuning the CAL or
calibrationutility(“5”fromthecontrolpanel)usingasmallscrewdriver
until the approximate operating temperature on both devices are
synchronized.
NOTE:PressingtheRESETbuttonremovesuser‐configuredsys‐
temvalues.Reconfigurationmaythenbenecessary.
OPERATING GUIDELINES