a Contents Our Product ---tenement Product gradients Packing List 30 Printer Instruction Power On install Filament Holder install Filament Load Lament Boot Settings Funnels Printing interface {loading Operations Unloading Operations Move Child Look Download introduction Things Trams La sign PRINT oneness 1 Sing Software prurience Overview Basic Parameters of X-MAKER BD Grinder eee eee 23 Daily Use of MAKER 24 Support oom 25 Our Product X-MAKER 3D Printer LD X-MAKER Design App Product Ingredients iw §& X-PRI
~& Packing List 7’ A & PLA Filament @ Filament Holder
~~ Power On Plug-in Power on Take out the power cord and connect the printer to the Press the power switch fo start the printer. power socket. (Please keep your hands dry) —-4¢ uninstall Filament Holder oo Filament inlet = Filament Inlet Right Install filament holder Place the lament Install the holder on the mainframes box and place Place the lament on the holder. the shamanism. {Pleads make sure the laments ars not knotted or intersected.
a uninstall Filament w-— Nee: The head end of lament should be straightened and cut into an oblique angle. Instruction Feds the lament into the guide pipe for about 3-cm. Push the spring upward {as shown by the red arrow in the figure), in make the lament enter smoothly. —& Load Filament se Loading has completed when lament outflows drum nozzle.
4 Boot Settings Wuhan the printer is powered on, please sel up the 3D printer according fo the prompts. Lunge i Candid dl Hosea Choose Language Connection Select your needed language. You can lase lick WI-FL With the same ELAN, MAKER App can be "Settings Language” io change it. connected to the printer Potshot: When no ELAN network is available, hols pot an the printer can provides Interment access (o the App.
4g Printing Interface #— Print Status Document Nam ¢ Currant TEMP of Nozzle @ Tarsal TEMP of Nozzle Modal Preview @Currant TEMP of Heated Bed Target TEMP of Heated Bed @ Current Z-ax Coordinate ® Progress Bar Elapsed Tie ¢ ® Pause/Resume Printing {Note: Printing can be coverage } Stop Printing {Note: Printing cannot be recovered } « Printing # Ware Control Set lings —4 Loading Operations Method 1 Lick Filament Load” and wah for heating until the filament outflows from nozzle.
Unloading Operations Method 1 Click "Filament -> Unload” and wall for heating uni ll the filament unloads from nozzle When "Uploading interface” Is closed, filaments can be uploaded from filament inlet. Method 2 Click “Preheat” -» Set largest temperature -> Click "Start”; Target TEMP for PLA laments 1s 200 °C. Target TEMP for ABS filaments is 230 °C. {You can refer to the target TEMP on the packing box for different laments} Click "Extrusion -> Unload" and set the returning length to 10mm.
-#i One-press Printing Automatic Task Division Automatic Slicing and Uploading Cr-press Printing Select the mods! and click * "1". The file will be divided info several tasks and you can preview the mode! in each task, Civic* "5 * again, and the mode! will be sliced automatically.
For printer stability and good models, please pay attention io the following matters: Dally Use of X-MAKER MED laments are recommended, Do not frequently sangs Laments of different brands or types Io avoid nozzle jamming. Filaments should be used up as soon a8 possible after opening. Please notice the supported versions when installing X-MAKER App. The App can be installed on some Android smartphones but coherence will be affected because of limited screen width.
