Specification
There are seven steps to installing a faucet:
INSTALLATION OF BASIN FAUCET
1.First,prepare the installation tool. Check whether the parte are complete before installation.Common faucet parts
include:hose,rubber ring,etc.In addition, waterproof tape should be prepared.
2.Check if the main valve of water supply is closed.
3.Use a waterproof tape to wrap a few turns in the clockwise direction on the thread of the faucet.( This is very
important.The direction of the waterproof tape must be tangled clockwise.lf twint revrsely,it will leak, which means
that the direction of the waterproof tape winding is opposite to the direction of he faucet thread) .
4.Install the faucet following the graphic instruction below.
5.Open the main valve of the water supply,normal water can be used.
6. The thread size is 9/16,it's meets the installation needs of most American house.
7.Button is functional when water pressure is applied.
PACKING ACCESSORIES
INSTALLATION STEPS
1. Make sure there are 5 mounting holes in
the panel. 1 The main body is put into the hole,
6 the following installation nut into 2 3 4 ,
and the main body link.
8
10
7
39
35
6
5
1
2
11
36
15
17
14
13
12
18
4
2. 5 7 The main body on the panel, 5 each
11 links installed，lock the main body with a
hexagonal spoon 5 ,Tighten the nut again.
4. 27 28
pipe 33 , Link 26 Hand shower,Lock the nut again.
Put the fixing rubber ring into the shower
5. 37 38 39 Link to double-headed tube.
6. 35 36 Connect hot and cold water pipes by logo.
31
32
27
33
28
26
37
23
24
21
20
19
38
25
3.19 21The main body on the panel, 19 each
25 links installed，lock the main body with a
hexagonal spoon 19 ,Tighten the nut again.
Cold
Hot
Tak e i t o ut