Specification

Table Of Contents

Instruction Manual

1、

2、

3、

8.66"

7: Connect the inlet hose to the angle valve

according to the hot and cold mark and tighten.

Before connecting, please confirm that there is

a sealing rubber gasket in the inlet hose connector

INSTALLATION STEPS

2.75"

5.9"

4.13"

2.75"

PAGE 1
INSTALLATION STEPS Instruction Manual 7: Connect the inlet hose to the angle valve according to the hot and cold mark and tighten. Before connecting, please confirm that there is a sealing rubber gasket in the inlet hose connector 8.66" 1、 2、 2.75" 4.13" 5.9" 2.
PAGE 2
PACKING ACCESSORIES INSTALLATION STEPS 26 1 5 19 12 20 13 6 21 14 1. Make sure there are 5 mounting holes in the panel. 1 The main body is put into the hole, 6 the following installation nut into 2 3 4 , and the main body link. 27 7 28 2 8 23 15 2. 5 7 The main body on the panel, 5 each 11 links installed，lock the main body with a hexagonal spoon 5 ,Tighten the nut again. 24 17 10 4 31 32 25 18 Take it out 11 33 39 37 38 3.