Specifications

53
or specified response should come back from the receiver after confirming the correct
command. If no response has been gained after a short while, the receiver has failed to
receive the command properly. Send a [CR] then re-send the command. Should problem
persist, check your connections and try reducing the RS-232C baud rate.
7-3 Detailed RS-232C command listing of the AR-ONE
X Power on x: any key to power on the AR-ONE (it takes 4 sec.)
QP Power off Power off
^Ann Remote ON Hex value 0x01
Accept a value nn in the range of 00-99 for remote
connection
EX Remote off Remote off
IDnn Remote ID To set: IDnn<CR>, nn: 00-99. To read:ID<CR>
RX MODE
Vx Select VFO To set: Vx<CR>, x:A – J (default :A)
MRmnn Memory mode m: 0 – 9 (memory bank), n: 00 – 99 (memory channel)
(default: 000)
MSm Memory scan mode m: 0 – 9 (memory bank), (default: 000)
SM Memory select mode
SSmm Search mode mm: 01 – 40 (search bank), (default: 01)
To read: RX <CR>
Response: Memory manual mode
MR MXmnn RFnnnnnnnnnn STnnnnnn Aun MDn BWn ATn AMn TMxxxxxxxx
Memory scan mode
MS MXmnn RFnnnnnnnnnn STnnnnnn Aun MDn BWn ATn Amn TMxxxxxxxx
Memory select mode
SM MXmnn RFnnnnnnnnnn STnnnnnn Aun MDn BWn Atn Amn TMxxxxxxxx
Search mode
SSmm RFnnnnnnnnnn STnnnnnn Aun MDn BWn Atn Amn TTxxxxxxxx
VFO mode
Vx RFnnnnnnnnnn STnnnnnn Aun MDn BWn Atn Amn (default: VFO-A)