Specifications

45
Push the ENT key to accept the data and return to a standard display. Alternatively, push the
ESC key to abort entry, or, push the down arrow key to move to the next item on the
configuration menu (RMT-ID).
6-9 Configure RMT-ID (Remote ID)
When multiple units are connected via remote connectors, each AR-ONE must be assigned
a different ID (address). The value is adjustable between 00 ~ 99. The default value is 00.
Important notice: It is extremely important to set the RMT-ID to 00 for normal operation
of the RS-232C connection.
To access the configuration menu, push the FUNC key and then push the 7 key.
Push the down arrow key to move the cursor to the “RMT-ID” selection point.
Use the main tuning dial, the right arrow key or the left arrow key to change the AR-ONE’s
RS-232C identification address.
Push the ENT key to accept the data and return to a standard display. Alternatively, push the
ESC key to abort entry, or, push the down arrow key to move to the next item on the
configuration menu (DELAY).
6-10 Configure DELAY (Scan delay and Search delay)
This parameter affects the time the AR-ONE will remain on an active frequency in scan or
search mode once the received signal has disappeared and the squelch has closed. This
is particularly useful for customizing how long the receiver will wait for a reply before
resuming scan or search. For example, passing communications back and forth
between a control tower / aircraft may take a few seconds. The limits are OFF / HOLD
and 0.1 to 0.9 seconds in 0.1 second increments. The default is 2.0 seconds.
To access the configuration menu, push the FUNC key and then push the 7 key.
Push the down arrow key to move the cursor to the “DELAY” selection point.