Specifications

29
When SCAN has been selected, only the currently displayed memory bank WHICH
CONTAINS DATA will be SCANNED, receive mode and frequency are unimportant. Any
memory channels which contain no data (empty) will be ignored (skipped).
4-3 Selecting a scan bank
The memory bank identifier (such as “3”) will be displayed on the middle right of the LCD.
If more than one memory channel is programmed into the current memory bank, and when
an ‘active’ channel has been located (busy, so the squelch opens), the scan process will
temporarily pause on the active channel, the memory location (such as “115”) will be
displayed along with any accompanying text (displayed underneath the memory location).
To select another memory bank for scanning, use the right arrow key or left arrow key.
If no data is available, the next bank with valid data will be recalled (empty memory banks
are skipped).
To exit from SCAN mode, push the VFO key.
4-4 Select scan
Select scan enables you to ‘tag’ memory channels to make a temporary list up to 50
channels in the same memory bank for scanning in a separate list called the SELECT SCAN
LIST.
4-4-1 Adding select scan channels in memory read
In memory read mode, push the FUNC key, and then push the 1 key to toggle the select
scan tag on/off, the icon “SEL” confirms selection.
4-4-2 Starting / stopping select scan
To start select scan, you must first have at least two memory channels tagged for select
scan.