Specifications

23
2-11 OFFSET
This function enables the receive frequency to be quickly SHIFTED by a predetermined
value, this makes it easy to track duplex-transmissions or check repeater inputs/outputs.
The locations for frequency offset storage are numbered 00 to 47 with 00 acting as OFF, this
makes 47 locations available.
Frequency offset may be programmed into VFO, memory channel and search banks. It is
most convenient to set-up in VFO mode then save the data to specific memory channels
for quick recall at a later date. Frequency offset is primarily designed for memory channel
use, it may appear rather long winded to toggle on/off in VFO mode. However even when
programmed, frequency offset is in no way detrimental to normal operation.
The acceptable range of frequency offset is 0 MHz to 999.999 MHz, of course if the offset is
set to 0 MHz, the frequency will not change! Before the FREQUENCY OFFSET function can
be used, it first needs to be configured.
2-11-1 Using pre-programmed frequency offset data
To access the frequency offset set-up menu, push the FUNC key, and then push the .
(decimal) key.
The third line will display DUPLEX followed by the current offset channel number.
Use the main tuning dial or arrow keys to review the offset locations. The shift direction
can be changed by pushing the FUNC key. To accept the offset setting, push the ENT key.
2-11-2 Entering new frequency offset data
Assume that you are in VFO mode.
To access the frequency offset set-up menu, perform the following steps:
1. Push the FUNC key, and then push the . (decimal) key. The third line will display