Specifications

14
The AR-ONE will take approximately 4 - 5 seconds before information appears on the
LCD. This is normal, while the AR-ONE microprocessor generates the ‘boot up data’
required to control the receiver.
2-3 Squelch Circuit
In normal use, NOISE SQUELCH is used. However, LEVEL SQUELCH can be selected for
search and scan operations. The LEVEL SQUELCH parameter causes the AR-ONE to
check the signal strength of active frequencies and to only stop when the signal strength is
above a preset level (which is programmable).
To select LEVEL SQUELCH, perform the following steps:
1. Push the FUNC key.
2. Push the “8” key.