Specifications

17
5. Configuration of the SDU5600
The SDU5600 is designed to configure a wide range of parameters for ease of operation.
5-1-1 Configuration (CONF)
This section explains how to configure the operating environment under which the SDU5600 is used.
Selection of the receiver, Plotting pattern and Frequency direction are to be configured. Press
the FUNC key followed by the 4 (CONF) key to assign the soft keys as the following diagram.
For selection of the receiver press the RX key.
The box where the type of receiver is shown will be in reverse contrast. Rotate the
main dial to scroll through applicable receivers one after another. Press the ENT key
(kHz key or MHz key) to determine the companion receiver. There are no other features
of the RX configuration menu.
For selection of the plot pattern press
PLOT key. The present pattern is shown
either as Paint or Outline. If you wish to
change the pattern from the one to
another press the PLOT key. There are no
other features of the PLOT configuration
menu.
For selection of the frequency direction
press the F-DIR key. The present
selection is shown either as Reverse or
Normal. Press the F-DIR key to toggle
between Reverse and Normal. This
configuration is valid only when the
companion receiver has been selected as
Other(10M) or Other(45M), it is not
applicable when a ‘known’ valid radio is
connected. There are no other features of
the F-DIR configuration menu.
This illustration shows PAINT mode:
This illustration shows OUTLINE mode:
Section 5, 5-1-1