Specifications

45
11. LAN (Local Area Network) control commands
Below is a command format for LAN control:
IP sub command parameter
(Note: No space must be inserted between the sub command and parameter.)
11-1 Readout settings from the optional LAN-box
IP RED IP RED
(Note: Each sub command will display all its stored data value on the
AR2300 until data readout is completed. Therefore, it is recommended
to use this command before changing /displaying the LAN settings. )
11-2 Write settings to the LAN-box
IP WRT IP WRT
(Note: This command is to write parameters to the LANBox.
Beware that using this command will write all parameters stored on the
AR2300 to the LANBox before executing the IP RED command.
This may result in the loss of parameters on the LANBox.)
11-3 IPv4 address
IP IPF IP IPFx.x.x.x x: 0 ~ 255 (IP address)
(default: 192.168.0.234)
To read: IP IPF<CR>
Response: IP IPFx.x.x.x
11-4 Mask address
IP
MSK
IP MSKx.x.x.x x: 0 ~ 255 (Mask address)
(default: 255.255.255.0)
To read: IP MSK<CR>
Response: IP MSKx.x.x.x
11-5 Gateway address
IP GAT IP GATx.x.x.x x: 0 ~ 255 (Gateway address)
(default: 192.168.0.1)
To read: IP GAT<CR>
Response: IP GATx.x.x.x