Specifications

17
2-1-2 Connect the antenna
For reception on the all bands, connect the antenna to the N connector on the rear panel of
the AR-ONE. An optional SA7000 Super Wideband Receiver is provided for this purpose.
A receive frequency range of the SA7000 is 30 KHz ~ 2000 MHz.
2-1-3 Connect power
Connect the power to the DC power jack on the rear panel of the AR-ONE. Use either a
supplied AC power adapter. Or a regulated DC power supply (12 ~ 14 V with capacity 2A)
may be used. Do not connect to a 24 V system.
Main Power Switch ___| |___ DC Power Jack
2-2 Switching On for the first time
Set the squelch control to the ‘mid point’ . Turn the power switch on the rear panel of the
AR-ONE. This is a main power switch. The Green LED lit on the switch. Then rotate the
PWR/VOL control to the ‘mid point’, as you start to rotate the PWR/VOL control, a ‘click’ will
be heard as the power isolation switch contact switches on. Please be careful NOT to
switch
on any receiver with an earphone connected, there may be an audible click when the unit is
switched on or the volume may be accidentally set too high.
Power/VOL control
•
•
Squelch control
The AR-ONE will take approximately 1 - 2 seconds before the information appears on the