User Manual

ManualsBrandsAOPUTTRIVER ManualsIndustrial & ScientificInfrared Thermometer AP-985B Pyrometer -50~1360 ℃ (-58~2480 ℉) with Data Storage, Background Lighting for Cooking Forge Melting Furnace Kilns

NAME：ZHUHAI JIDA HUAPU INSTRUMENT CO.,LTD

ADD：2/F Build 6 & 6/F Build 5,#19 YongTian Road,Zhuhai,China

TEL：+86-756-3374032 3370320 8987885 8982619

FAX：+86-756-3333971

E-mail：hp@holdpeak.com

Http://www.holdpeak.com

Non-contact infrared thermometer

HP-985B

Instruction manual

Summary of content (6 pages)

PAGE 1
HP-985B Non-contact infrared thermometer Instruction manual NAME：ZHUHAI JIDA HUAPU INSTRUMENT CO.,LTD ADD：2/F Build 6 & 6/F Build 5,#19 YongTian Road,Zhuhai,China TEL：+86-756-3374032 3370320 8987885 8982619 FAX：+86-756-3333971 E-mail：hp@holdpeak.com Http://www.holdpeak.
PAGE 2
TABLE OF CONTENTS 1. Instroduction..........................................................................................................1/3 2. Quick start instruction...........................................................................................3/5 3. Maintenance..............................................................................................................6 4. Specifications........................................................................................................
PAGE 3
1ǃIntroduction Compact, rugged and easy to use. Just aim and push the button, read current surface temperatures in less than a second. Safely measure surface temperatures of hot, hazardous or hard-to-reach objects without contact. How it works Infrared thermometer measures the surface temperature of an object. The unit’s optics sense emitted, reflected, and transmitted energy which is collect and focused onto a detector. The unit’s electronics transmitted energy which is display on the unit.
PAGE 4
--Do not leave the unit on or near objects of high temperature. Warning Do not point laser at eye or indirectly off reflective surfaces. 1. When take measurement, point thermometer toward the object to be measured and hold the yellow trigger. The object under test should be large than the spot size calculated by the field of view diagram. 2. Distance ˂ spot size: As the distance from the object increase, the spot size of measuring area becomes large.
PAGE 5
4.Replae the battery and put the rubber sleeve and the cover back. 3ǃMaintenance 1) Lens cleaning: Blow off lose particles using clean compressed air. Gently brush remaining debris away with a moist cotton cloth. 2) Case cleaning: Clean the case with a damp sponge/cloth and mild soap. 3) Please take out the battery when not using for a long time. Note: 1) Do not use solvent to clean lens. 2) Do not submerge the unit in water. 3) Emissivity will back to the initial value (0.95) after replacing battery,.
PAGE 6
set alarm temperature. When LCD display ” HI” means measure result exceeded the alarm temperature˗ EǃLAL˖Alarm of low temperature. Option HAL mode, press“UP/DN”button for (5) 2. Locating a hot spot aim the thermometer outside the area of interest, then scan across with up and down motions until you locate the hot spot.(please turn on the laser to for accurate measuring) 3.