User manual

Anypos600 Point of Service
HARD D
ISK(S) FAIL
(10)
Unable to recalibrate fixed
disk.
Have the Anypos
serviced.
KEYBOARD IS
LOCKED OUT -
UNLOCK THE KEY
The keyboard is locked and
the key-board controller is
pulled low.
Have the Anypos
serviced.
KEYBOARD ERROR
OR NO KEYBOARD
PRESENT
A keyboard is not detected.
Make sure the keyboard
is attached correctly and
no key is pressed during
boot.
MANUFACTURING
POST LOOP
System keeps rebooting
because the keyboard
controller is pulled low for
testing purposes.
Have the Anypos
serviced.
BIOS ROM CHECKSUM
ERROR - SYSTEM
HALTED
The ROM address is
incorrect.
Have the Anypos
serviced.
MEMORY TEST FAIL
The memory card is not
correctly installed or is
damaged.
Have the Anypos
serviced.
General Problems
Refer to the following general problems you may encounter.
PROBLEM SOLUTION
The display screen is dark.
Make sure that the Power LED is on and Anypos is not
in suspend mode, and adjust the display brightness.
An incorrect date and time
a
re displayed.
Correct the date and time using the DOS DATE and
T
IME commands or the options in the Setup Utility. (You
c
an also set the date and ti
m
e in Windows by double
c
licking the clock on the task bar or in the control panel.)
I
f the date and time become incorrect after a short time,
t
he CMOS battery may be depleted. Replace the battery.
The following message
a
ppears at boot up: “Invalid
syste
m
disk, Replace the
d
isk, and then press any
k
ey”
Ensure that an operating system is installed. Check the
b
oot sequence in the BIOS setup utility.
You hear irregular beeps
d
uring operation of the
c
omputer and the system
h
alts.
Have the Anypos serviced.
An unidentified message is
d
isplayed.
Reboot the computer and run the BIOS Setup Utility.
C
onfirm the Setup Utility parameters. If the same
m
essage is displayed after booting up again,
You cannot operate the
p
rinter.
Check the printer cable connection. Ensure that the
p
rinter power switch is turned on. Confirm that the printer
i
s on-line.
23