Installation guide
Quick Installation Guide
Hardware installation
Please follow the steps below to configure your motherboard.
1. Plugging CPU and Connecting CPU Fan
—I 'l—1' U LI
Plug in the fan cable to the 3-pin CPUFAN1 or FAN1
connector. Both of these two fan connectors support
hardware monitoring function, however, you can only
use the CPU FAN connector to control the fan power
ON/OFF.
2. Setting AGP Frequency
According to the CPU you use, 66MHz AGP frequency is automatically determined by chipset.
But this jumper can be used to manually decide AGP frequency when you are overclocking. We
recommend choosing a better AGP card for 1/1 AGP turbo overclocking. Some AGP card can not
support 100MHz bus frequency.
in in I IUI
JP23 JP23
JP23
1 r—j|2
1
о о
2 1
lOlQl
2
3 |°|°U
3
4
3
|о|о| 4
5^6
5
о о
6
5
шш
6
Auto
2/3 1/1
(Default)
3. Connecting Front Panel Cable
Attach the power LED, keylock, speaker, and reset switch connectors to the corresponding pins. If
you enable "Suspend Mode" item in BIOS Setup, the ACPI & Power LED will keep flashing while
the system is in suspend mode.
Locate the power switch cable from your housing. It is 2-pin female connector from the housing
front panel. Plug this connector to the soft-power switch connector marked SPWR.
IMP—PI ILI
bUU.,—O—
0
о
Keylock +
О
О
О
о
О
о
о
о
о
+ SPWR
IDE LED
+
+
8
о
о
О
о
О
о
о
о
о
+ ACPI &
Power LED
+
Speaker
о
о
о
о
+ ACPI &
Power LED
+
Speaker
о
о
о
о
Reset
~3~