User Guide
Table Of Contents
- MX46LS
- Hardware Installation
- About “Optional” and “Upgrade Optional”…
- JP14 Clear CMOS Data
- CPU Installation
- CPU Jumper-less Design
- CPU and System Fan Connector (with H/W Monitoring)
- JP28 USB Keyboard / Mouse Wakeup
- DIMM Sockets
- Front Panel Connector
- ATX Power Connector
- AC Power Auto Recovery
- IDE and Floppy Connector
- IrDA Connector
- AGP (Accelerated Graphic Port) Expansion Slot
- WOM (Zero Voltage Wake on Modem) Connector
- WOM by External BOX Modem
- WOM by Internal Modem Card
- WOL (Wake on LAN)
- Support 10/100 Mbps LAN onboard
- CNR (Communication and Network Riser) Expansion Slot
- PC99 Color Coded Back Panel
- Support 3 USB Ports
- CD Audio Connector
- Modem Audio Connector
- Front Audio Connector
- Dr. LED Connector (Upgrade Optional)
- Battery-less and Long Life Design
- Over-current Protection
- Hardware Monitoring
- Resettable Fuse
- 1500μF Low ESR Capacitor
- Layout (Frequency Isolation Wall)
- Pure Aluminum Heatsink
- Driver and Utility
- AWARD BIOS
- Overclocking
- Glossary
- AC97
- ACPI (Advanced Configuration & Power Interface)
- AGP (Accelerated Graphic Port)
- AMR (Audio/Modem Riser)
- Bonus Pack CD
- APM (Advanced Power Management)
- ATA (AT Attachment)
- ATA/66
- ATA/100
- BIOS (Basic Input/Output System)
- Bus Master IDE (DMA mode)
- CNR (Communication and Networking Riser)
- CODEC (Coding and Decoding)
- DDR (Double Data Rated) SDRAM
- DIMM (Dual In Line Memory Module)
- DMA (Direct Memory Access)
- ECC (Error Checking and Correction)
- EDO (Extended Data Output) Memory
- EEPROM (Electronic Erasable Programmable ROM)
- EPROM (Erasable Programmable ROM)
- EV6 Bus
- FCC DoC (Declaration of Conformity)
- FC-PGA (Flip Chip-Pin Grid Array)
- Flash ROM
- FSB (Front Side Bus) Clock
- I2C Bus
- IEEE 1394
- Parity Bit
- PBSRAM (Pipelined Burst SRAM)
- PC-100 DIMM
- PC-133 DIMM
- PC-1600 or PC-2100 DDR DRAM
- PCI (Peripheral Component Interface) Bus
- PDF Format
- PnP (Plug and Play)
- POST (Power-On Self Test)
- RDRAM (Rambus DRAM)
- RIMM (Rambus Inline Memory Module)
- SDRAM (Synchronous DRAM)
- Shadow E2PROM
- SIMM (Single In Line Memory Module)
- SMBus (System Management Bus)
- SPD (Serial Presence Detect)
- Ultra DMA
- USB (Universal Serial Bus)
- VCM (Virtual Channel Memory)
- ZIP file
- Troubleshooting
- Technical Support
- Product Registration
- How to Contact Us

M
M
X
X
4
4
6
6
L
L
S
S
O
O
n
n
l
l
i
i
n
n
e
e
M
M
a
a
n
n
u
u
a
a
l
l
B
B
a
a
t
t
t
t
e
e
r
r
y
y
-
-
l
l
e
e
s
s
s
s
a
a
n
n
d
d
L
L
o
o
n
n
g
g
L
L
i
i
f
f
e
e
D
D
e
e
s
s
i
i
g
g
n
n
This Motherboard implements Flash ROM and a special circuit that allows you to save your current CPU and CMOS Setup configurations
without the need of a battery. The RTC (real time clock) can also keep running as long as the power cord is plugged. If you lose your
CMOS data by accident, you can just reload the CMOS configurations from Flash ROM and the system will recover as usual.
Battery
ATX Stand-by Power
Backup by EEPROM
Auto Switch
RTC
(Real Time Clock)
00:00:00
Flash ROM
CMOS
A
uto switching to ATX standby powe
r
as long as AC power line is plugged.
This smart design increases battery
life if you still plug battery on
motherboard.
50










