Specifications
Table Of Contents
- MX3W-E3 / MX3W-V3
- Hardware Installation
- About “Optional” and “Upgrade Optional”…
- Clear CMOS Data
- CPU Installation
- JP23 Adjust FSB/PCI Clock Ratio
- CPU Jumper-less Design
- CPU and Housing Fan Connector (with H/W Monitoring)
- DIMM Socket
- Front Panel Connector
- ATX Power Connector
- JP28 Keyboard/Mouse Wake-up
- Power and RAM Power Indicate LED
- AC Power Auto Recovery
- IDE and Floppy Connector
- IrDA Connector
- WOM (Zero Voltage Wake on Modem) Connector
- WOL (Wake on LAN)
- CNR (Communication and Network Riser) Expansion Slot
- Support IntelR PRO/100 Network Connection (Optional)
- JP13 LAN Enable / Disable Select Jumper (Optional)
- PC99 Color Coded Back Panel
- COM2 Connector
- Support 2nd USB Port
- DVO (Digital Video Out) Connector
- Chassis Intrusion Sensor
- CD Audio Connector
- Modem Audio Connector
- AUX-IN Connector
- Front Audio Connector
- GPO (General Purpose Output) Connector
- Over-current Protection
- Hardware Monitoring
- Resettable Fuse
- Low ESR Capacitor
- Layout (Frequency Isolation Wall)
- Driver and Utility
- AWARD BIOS
- Overclocking
- Glossary
- AC97
- ACPI (Advanced Configuration & Power Interface)
- AGP (Accelerated Graphic Port)
- AMR (Audio/Modem Riser)
- AOpen Bonus Pack CD
- APM (Advanced Power Management)
- ATA (AT Attachment)
- ATA/66
- ATA/100
- BIOS (Basic Input/Output System)
- Bus Master IDE (DMA mode)
- CNR (Communication and Networking Riser)
- CODEC (Coding and Decoding)
- DDR (Double Data Rated) SDRAM
- DIMM (Dual In Line Memory Module)
- DMA (Direct Memory Access)
- ECC (Error Checking and Correction)
- EDO (Extended Data Output) Memory
- EEPROM (Electronic Erasable Programmable ROM)
- EPROM (Erasable Programmable ROM)
- EV6 Bus
- FCC DoC (Declaration of Conformity)
- FC-PGA (Flip Chip-Pin Grid Array)
- Flash ROM
- FSB (Front Side Bus) Clock
- I2C Bus
- IEEE 1394
- Parity Bit
- PBSRAM (Pipelined Burst SRAM)
- PC-100 DIMM
- PC-133 DIMM
- PC-1600 or PC-2100 DDR DRAM
- PCI (Peripheral Component Interface) Bus
- PDF Format
- PnP (Plug and Play)
- POST (Power-On Self Test)
- RDRAM (Rambus DRAM)
- RIMM (Rambus Inline Memory Module)
- SDRAM (Synchronous DRAM)
- Shadow E2PROM
- SIMM (Single In Line Memory Module)
- SMBus (System Management Bus)
- SPD (Serial Presence Detect)
- Ultra DMA
- USB (Universal Serial Bus)
- VCM (Virtual Channel Memory)
- ZIP file
- Troubleshooting
- Technical Support
- Product Registration
- How to Contact Us

M
M
X
X
3
3
W
W
-
-
E
E
3
3
/
/
M
M
X
X
3
3
W
W
-
-
V
V
3
3
O
O
n
n
l
l
i
i
n
n
e
e
M
M
a
a
n
n
u
u
a
a
l
l
PCI Clock = CPU FSB Clock / Clock Ratio
AGP Clock = PCI Clock x 2
Clock Ratio CPU (Host) PCI AGP Memory
2X 66MHz 33MHz 66 PCI x2 or x3
2X, overclocking 75MHz 37.5MHz 75MHz PCI x2 or x3
3X 100MHz 33MHz 66MHz PCI x2 or x3 or x4
3X, overclocking 112MHz 37.3MHz 74.6MHz PCI x2 or x3 or x4
4X 133MHz 33MHz 66MHz PCI x3 or x4
4X, overclocking 155MHz 38.75MHz 77.5MHz PCI x3 or x4
Warning: Intel® 810E chipset supports maximum 133MHz FSB
and 810 chipset supports maximum 100MHz FSB. Both support
66MHz AGP clock. Higher clock setting may cause serious
system damage.
23