Service manual

4. DISASSEMBLY AND ASSEMBLY
Service Manual CNS-9701 4.15
Removing the Display Unit
Chassis
6. Remove the 4 screws (3 mm in dia.) and 6 screws (4 mm in dia.) which secure
the chassis to the rear cover.
7. Pull the lower edge of the chassis upward until you can disconnect the cables
from the boards on the chassis backside. Disconnect all cables from the boards
and remove the chassis from the display unit.
CAUTION
If the display unit has a separate wire from the power supply cable for
the inverter, cut the wire to separate the chassis from the rear cover.
When assembling the display unit, solder the cut wire together.
Refer to the following
CAUTION.
Lower edge of
the chassis
Chassis LCD control board inside
Audio board
Touch screen control board
<Backside of chassis>