Service manual

4. DISASSEMBLY AND ASSEMBLY

4.6 Service Manual CNS-9701

10. Remove the 6 screws which secure the motherboard to the chassis. Remove the

motherboard from the main unit.

NOTE in Assembling the Main Unit

To attach the motherboard to the main unit, tighten the 6 screws while

pushing the motherboard to the rear panel until the 6 holes of the

motherboard match the screw holes of the chassis.

11. Depress the white hooks which fasten the DIMM board to the socket. Remove the

DIMM board from the motherboard.

NOTE in Assembling the Main Unit

To attach the DIMM board to the motherboard, insert the DIMM board

into the DIMM1 socket on the motherboard. Latch the DIMM board with

the hooks.

<Vorax5000> When the main unit is Vorax5001, go to step 12 of <Vorax5001>.

12. Disconnect the brown connector of the CPU fan cable from the motherboard.

13. Release the 4 hooks of the CPU fan as shown below by inserting a small flat-

blade screwdriver between the longer hook of the CPU fan and heat sink. Remove

the CPU fan from the motherboard.

Hook

CPU fan