Service manual

8. NETWORK SETTINGS
8.16 Service Manual CNS-9701
Assigning a Group Name
Checking the Bed Name
and Group Name Setting
Group name
All monitors connected to the
network are sorted by group.
Assign a group name to the central monitor, beds on the multiple patient receiver
and bedside monitors on the network, respectively. The factory default setting
group name for each instrument is “General”. If you do not divide instruments on
a network into groups, assigning a group name is not necessary.
Central monitor:
Set the group name on the Name Registration window of the System Setup on the
central monitor. Refer to the CNS-9701 operator’s manual.
Beds via the ORG-9200 multiple patient receiver:
Set the group name on the ORG Setting window of the System Setup on the central
monitor. Refer to the CNS-9701 operator’s manual.
Bedside monitors:
Assign the group name to bedside monitors on the SYSTEM SETUP screen on
each bedside monitor. Refer to the bedside monitor operator’s manual.
When the group name does not appear on the SYSTEM SETUP screen on the
bedside monitors:
1. Turn off then turn on the bedside monitor.
2. Wait for 30 seconds and display the SYSTEM SETUP screen. The group name
appears on the screen.
On the Monitor Setting window of the System Setup on the central monitor, you
can check if the bed name and group name are properly assigned to each bed.
Refer to the CNS-9701 operator’s manual.