Service manual

4. DISASSEMBLY AND ASSEMBLY
Service Manual CNS-9701 4.21
4. Pull the recorder sub assy toward you until you can see 2 screws at the bottom
of the recorder sub assy.
5. Remove the 2 screws which secure the paper tray to the recorder sub assy and
remove the paper tray from the recorder sub assy.
6. Disconnect the flat cable between the recorder sub assy and RS232C interface
board. Remove the recorder sub assy from the recorder unit.
1. Remove the enclosure from the recorder unit according to the “Removing the
Recorder Sub Assy” steps 1 to 2.
2. Remove the insulation cover from the AC inlet socket.
3. Insert a small flat-blade screwdrivers into the AC inlet socket upper clearance
to release the upper latch of the AC inlet socket.
4. Insert a small flat-blade screwdrivers into the AC inlet socket lower clearance
to release the lower latch of the AC inlet socket. Remove the AC inlet socket
from the recorder unit.
Removing the AC Inlet
Socket
Upper latch
Lower latch