User Guide
Table Of Contents
- Mk73LE-N / MK73LE-V
- Hardware Installation
- JP14 Clear CMOS Data
- CPU Installation
- JP21 Adjust FSB/PCI Clock
- CPU Jumper-less Design
- Setting CPU Core Voltage
- CPU and Housing Fan Connector(With H/W Monitoring)
- DIMM Socket
- How to install memory module
- Front Panel Connector
- ATX Power Connector
- AC Power Auto Recovery
- IDE and Floppy Connector
- IrDA Connector
- WOM (Zero Voltage Wake on Modem) Connector
- WOL (Wake on LAN)
- CNR Expansion Slot
- Support Realtek 10/100 Mbps LAN onboard (MX73LE-N Only)
- JP13 LAN Enable / Disable Select Jumper (MX73LE-N Only)
- PC99 Color Coded Back Panel
- COM2 Connector
- Support 2nd USB Port
- CD Audio Connector
- Modem Audio Connector
- AUX-IN Connector
- Front Audio Connector
- GPO (General Purpose Output) Connector
- Battery-less and Long Life Design
- Over-current Protection
- Hardware Monitoring
- Resettable Fuse
- Low ESR Capacitor
- Layout (Frequency Isolation Wall)
- Driver and Utility
- Autorun Menu from Bonus CD Disc
- Installing Windows 95
- Installing Windows 98
- Installing Windows 98 SE, Windows ME & Windows2000
- Installing VIA 4 in 1 Driver
- Installing Onboard Sound Driver
- Installing Onboard AGP Driver
- Installing LAN Driver (MK73LE-N Only)
- Installing Hardware Monitoring Utility
- ACPI Suspend to Hard Drive
- ACPI Suspend to RAM (STR)
- AWARD BIOS
- Overclocking
- Glossary
- AC97
- ACPI (Advanced Configuration & Power Interface)
- AGP (Accelerated Graphic Port)
- AMR (Audio/Modem Riser)
- AOpen Bonus Pack CD
- APM (Advanced Power Management)
- ATA (AT Attachment)
- ATA/66
- ATA/100
- BIOS (Basic Input/Output System)
- Bus Master IDE (DMA mode)
- CNR (Communication and Networking Riser)
- CODEC (Coding and Decoding)
- DIMM (Dual In Line Memory Module)
- ECC (Error Checking and Correction)
- EDO (Extended Data Output) Memory
- EEPROM (Electronic Erasable Programmable ROM)
- EPROM (Erasable Programmable ROM)
- EV6 Bus
- FCC DoC (Declaration of Conformity)
- FC-PGA (Flip Chip-Pin Grid Array)
- Flash ROM
- FSB (Front Side Bus) Clock
- I2C Bus
- IEEE 1394
- Parity Bit
- PBSRAM (Pipelined Burst SRAM)
- PC-100 DIMM
- PC-133 DIMM
- PCI (Peripheral Component Interface) Bus
- PDF Format
- PnP (Plug and Play)
- POST (Power-On Self Test)
- RDRAM (Rambus DRAM)
- RIMM (Rambus Inline Memory Module)
- SDRAM (Synchronous DRAM)
- Shadow E2PROM
- SIMM (Single In Line Memory Module)
- SMBus (System Management Bus)
- SPD (Serial Presence Detect)
- UltraATA
- USB (Universal Serial Bus)
- VCM (Virtual Channel Memory)
- ZIP file
- Troubleshooting
- Technical Support
- Product Registration

M
M
K
K
7
7
3
3
L
L
E
E
-
-
N
N
/
/
M
M
K
K
7
7
3
3
L
L
E
E
-
-
V
V
O
O
n
n
l
l
i
i
n
n
e
e
M
M
a
a
n
n
u
u
a
a
l
l
O
O
v
v
e
e
r
r
-
-
c
c
u
u
r
r
r
r
e
e
n
n
t
t
P
P
r
r
o
o
t
t
e
e
c
c
t
t
i
i
o
o
n
n
The Over Current Protection was very popular implemented on ATX 3.3V/5V/12V switching power supply. However, the new
generation CPU uses different voltage that has regulator to transfer 5V to CPU voltage (for example, 2.0V), and makes 5V over
current protection useless. This motherboard is with switching regulator onboard supports CPU over-current protection; in
conjunction with 3.3V/5V/12V power supply provide the full line over-current protection.
12V (Protected by power supply)
5V (Protected by power supply)
Over-Current
Protection
Circuit
Onboard
Power
Regulator
ATX
Switching
Power
Supply
3.3V (Protected by power supply)
CPU Core Voltage
53










