Installation guide

55
ECP Mode Use DMA: This item lets you set the DMA channel of ECP mode.
Available options: 3, 1
AC Power Auto Recovery: A traditional ATX system should remain at power
off stage when AC power resumes from power failure. This design is
inconvenient for a network server or workstation, without an UPS, that needs
to keep power-on. This item is used to solve this problem. Selecting On
enabling system to automatically power-on after AC power resumes; in the
other hand, the system will remain power-off if you select Off. If Former-Sts
(former status) option is selected, the system will power-on or power-off
based on the original state. Available options: Former-Sts, On, Off
Integrated peripherals > USB Controller:
This item lets you enable or
disable the USB controller.
Integrated peripherals > USB 2.0 Controller: This item lets you enable
or disable the USB 2.0 controller.
Integrated peripherals > USB Keyboard Support:
This item lets you
enable or disable the USB keyboard driver within the onboard BIOS. The
keyboard driver simulates legacy keyboard command and let you use USB
keyboard during POST or after boot if you don't have USB driver in the
operating system.
Integrated peripherals > On Board Audio Codec:
This item is used to
enable or disable the onboard audio.
Integrated peripherals > Onboard 1394 Control: This item lets you
enable or disable onboard 1394.
Integrated peripherals > Onboard LAN1 Control: This item lets you
enable or disable onboard LAN.