Installation guide

54
KB Power ON Password: You can specify 1-5 keys as a password.
Hot Key Power On: If you select “Hot Key” option in “Power On Function”
Item, you need to specify a hot key here.
Onboard FDC Controller:
Setting this parameter to “Enabled“ allowing you
to connect your floppy disk drives to the onboard floppy disk connector
instead of a separate controller card. Change the setting to Disabled if you
want to use a separate controller card.
Onboard Serial Port 1:
This item allows you to assign address and interrupt
for the board serial port. The default is “Auto”.
Onboard Serial Port 2:
This item allows you to assign address and interrupt
for the board serial port. The default is “Auto”.
UART Mode Select: This item is configurable only if the "Onboard Serial Port
2" is enabled. This allows you to specify the mode of serial port2. Available
options:
z Normal:
Sets serial port 2 to operate in normal mode. This is the default
setting.
z IrDA (SIR): This setting allows infrared serial communication at a
maximum baud rate of 115.2K baud.
z ASKIR: This setting allows infrared serial communication at a maximum
baud rate of 57.6K baud.
RXD, TXD Active: This item is used to select RxD (Receive Data) and TxD
(Transmit Data) mode for UART, for instance, IR device, modem, etc.
Normally, we suggest you keep the default setting. Please see the
documentation that comes with your device. Available options: Hi, Hi / Hi, Lo
IR Transmission Delay: If “Enabled” is selected, there will be a 4
character delay when SIR is changed from TX mode to RX mode.
Onboard Parallel Port: This item controls the onboard parallel port address
and interrupt. Available options: 3BC/IRQ7, 3BC/IRQ7, 3BC/IRQ7,
Disabled
Parallel Port Mode:
This item lets you set the parallel port mode. The
mode options are SPP (Standard and Bidirection Parallel Port), EPP (Enhanced
Parallel Port) and ECP (Extended Parallel Port). Available options:
z SPP (Standard and Bidirection Paralell Port): SPP is the IBM AT
and PS/2 compatible mode.
z EPP (Enhanced Parallel Port): EPP enhances the parallel port
throughput by directly writing/reading data to/from parallel port
without latch.
z ECP (Extend Parallel Port): ECP supports DMA and RLE (Run Length
Encoded) compression and decompression.
z ECP + EPP
EPP Mode Select: This item lets you select EPP mode protocol.
Available options: EPP 1.7, EPP 1.9