Specifications


2. Ensure that you have wired Internet access through your broadband modem before you attempt to set up a wireless Internet connection (see
ConnectingaNetworkorBroadbandModemCable).

3. Install any software required for your wireless router. Your wireless router may have been shipped with installation media. Installation media usually
contains installation and troubleshooting information. Install the required software according to the instructions provided by the router manufacturer.

4. Shut down your computer and any other wireless-enabled computers in the vicinity through the Windows Vista Start button , or Start® Shutdown in
Windows XP.

5. Disconnect your broadband modem power cable from the electrical outlet.

6. Disconnect the network cable from the computer and the modem.

7. Disconnect the AC adapter cable from your wireless router to ensure that there is no power connected to the router.

8. Insert a network cable into the network (RJ-45) connector on the unpowered broadband modem.

9. Connect the other end of the network cable into the Internet network (RJ-45) connector on the unpowered wireless router.

10. Ensure that no network or USB cables, other than the network cable connecting the modem and the wireless router, are connected to the broadband
modem.

11. Turn on only your broadband modem and wait for at least 2 minutes for the broadband modem to stabilize. After 2 minutes, proceed to step 12.

12. Turn on your wireless router and wait for at least 2 minutes for the wireless router to stabilize. After 2 minutes, proceed to the step 13.

13. Start your computer and wait until the boot process completes.

14. See the documentation that came with your wireless router to do the following in order to set up the wireless router:
l Establish communication between your computer and your wireless router.
l Configure your wireless router to communicate with your broadband router.
l Find out your wireless router's broadcast name. The technical term for the name of your router's broadcast name is Service Set Identifier (SSID)
or network name.

15. If necessary, configure your wireless network card to connect to the wireless network (see Connecting to a WLAN).

Connecting to a WLAN
This section provides general procedures for connecting to a network using wireless technology. Specific network names and configuration details vary. See
Wireless Local Area Network for more information about how to prepare for connecting your computer to a WLAN.
Your wireless network card requires specific software and drivers for connecting to a network. The software is already installed.
When you turn on your computer and a network (for which your computer is not configured) is detected in the area, a pop-up appears near the network icon
in the Windows notification area.
To connect to the network:

1. Click Start , and then click Network.

2. Click Network and Sharing on the navigation bar at the top of the Network folder.

3. Click Connect to a network under Tasks.

4. Select your network from the list and click Connect.
NOTE: Wait for a minimum of 5 minutes after disconnecting your broadband modem before continuing with the network setup.
NOTE: Restart your wireless equipment in the order described below to prevent a potential connection failure.
NOTE: Before you connect to a WLAN, ensure that you have followed the instructions in Wireless Local Area Network.
NOTE: The following networking instructions do not apply to internal cards with Bluetooth®wireless technology or cellular products.
NOTE: If the software is removed or corrupted, follow the instructions in the user documentation for your wireless network card. Verify the type of
wirelessnetworkcardinstalledinyourcomputerandthensearchforthatnameontheDell™Supportwebsiteatsupport.dell.com. For information on
the type of wireless network card that is installed in your computer, see Checking Your Wireless Network Card.