Installation manual

STEP 4. Level the unit from left to right and front to back.
- Adjust the unit down by lifting up on the buckle.
- Adjust the unit up by pulling down vertically on the Hand
Loops while lifting up the bottom of the cabinet.
H
and Loops
Buckles
P
ull down on the hand
loops while lifting
the bottom of the unit.
Hand Loops
Screws (not included)
Buckles
Joist
Washers (not included)
Hanging Strap grommets
“S” hooks
Note:This illustration of the unit may
vary from the unit you are installing.
DETAIL
Suspend the Unit with the Adjustable Hanging Straps (150ERV and 200ERV)
STEP 1. Insert the screws and washers (not included) through
the Hanging Strap grommets and fasten to the joists.
STEP 2. Unscrew the 4 machine screws located on the upper
side of the unit. Attach the "S" hooks and reinsert the machine
screws.
STEP 3. Hook the bottom grommets of the straps through the "S"
hooks. Pull down vertically on the hand loops while lifting up the
bottom of the cabinet. Repeat at opposite end of the unit.
Hand Loops
Straps
STEP 5. Fold the hand loops and excess strap and secure with a
nylon tie (not included).
Use 4 screws and 4 washers (not incldued) to attach the hanging
straps to the floor joists. The washer must be wider than the eyelet
of the grommet on the hanging strap.
By design, the adjustable hanging straps reduce the possibility of
noise, resonance and harmonics.
Note: Do not pull the
Hand Loops in a
horizontal or lateral
direction during the
installation/adjustment
process.
19
Suspending the RNC120F
Adjustable height
“L” Brackets
The unit must be mounted level for proper
drainage of the condensate pans.
ATTENTION
Suspending the RNC120F
It is important to isolate the “L” BRACKET from the attached
surface to minimize vibration. Use the hardware provided to
attach the brackets. Do not drill additional holes in the HRV.