Installation manual

Location Selection
Install the ERV in a space conveniently located for servicing the
unit. A typical location for the ERV is in a Mechanical room or in
an area close to the outside wall where the weatherhoods are
mounted. If a convenient area in the basement does not exist, a
utility or laundry room is acceptable.
Install the unit in a horizontal position suspended with the hanging
straps provided. Leave sufficient clearance below the access door
for servicing the air filters and core.
Improper installation, adjustment, alteration,
service or maintenance can cause property
damage, personal injury or loss of life.
Installation and service must be performed by
a qualified installer or service agency.
WARNING
Electric shock hazard. Can cause
injury or death. Before attempting to
perform any service or maintenance,
turn the electrical power unit OFF at
disconnect switch(es). Unit may have
multiple power supplies.
WARNING
Installation Requirements (ERV)
Connecting Appliances to the ERV
The following appliances should not be connected to the ERV:
• clothes dryer
• range top
• stove top exhaust fan
• central vacuum system
NOTE: Connecting any of these items to the ERV will invalidate
your warranty.
WARNING
Before installation, careful consideration must be
given to how this system will operate if connected
to any other piece of mechanical equipment, i.e. a
forced air furnace or air handler, operating at a
higher static. After installation, the compatibility of
the two pieces of equipment must be confirmed, by
measuring the air flows of the ERV, by using the
balancing procedure found in this manual.
It is important to assess how the operation of an
ERV will interact with vented combustion
equipment (i.e. Gas Furnaces, Oil Furnaces, Wood
Stoves etc.).
NEVER install a ventilator in a situation where its
normal operation, lack of operation or partial
failure may result in the backdrafting or improper
functioning of vented combustion equipment.
18