User Guide

4
The Configuration jumper is for selection of the drive use mode and supporting PC.
Short-circuit socket is attached for the setting. (attached -> on; not attached -> off)
Pin
Name
Function
1
MA
ON
The drive is used in master mode.
2
SL
ON
The drive is used in slave mode.
3
CS
ON
Mode for drive setting by CSEL of the IDE interface.
4
Reserved.
ON
Stay in RPC Phase I mode.
5
RPC
SET
OFF
Start RPC Phase II mode (Never return to Phase I mode
after Phase II mode is used.)
NOTE: For a DVD Video playback system (computer) for Phase I, please use with
Phase I. When the DVD Video playback system (computer) and the drive
have different region codes. DVD Video playback is not possible. Set the
jumper switch to OFF only when use of a drive corresponding to Phase II has
been specified clearly for the DVD Video playback system (computer). This
drive will be initialized automatically and will operate in Phase II mode.
NOTE: Normally, the red edge of the IDE cable corresponds to pin 1 of the IDE
interface on the DVD-ROM drive.
NOTE: The DVD-ROM drive supports Ultra DMA/33 mode to improve IDE data
transfer rate. To implement this function, you also need to make sure your
motherboard supports UDMA mode and the bus master IDE driver has been
installed properly.
U
U
s
s
i
i
n
n
g
g
t
t
h
h
e
e
D
D
V
V
D
D
-
-
R
R
O
O
M
M
D
D
r
r
i
i
v
v
e
e
In most cases, software applications that utilize DVD-ROM drives control the DVD-
ROM drive operations directly. However, you can control the drive manually using the
front-panel controls.
1. Headphone Jack
2. Volume Control
3. Power-on/Busy LED
4. Load/Eject Button
5. Disc Tray