User Guide

9
1. Factory use only (No jumper pin)
2.
3. SCSI ID setting
4.
5. Factory use only (No jumper pin)
6. TERMINATOR setting
7. Factory use only (No jumper pin)
Terminator setting (Factory Default: ON)
A terminator refers to a terminating resistance. The terminators must be set properly
when SCSI units (including the DVD-RAM drive) have been connected to the
personal computer.
When the DVD-RAM drive is a terminating device
(for example, illustration A, G), set to ON.
When the DVD-RAM drive is not a terminating
device (for example, illustration B-F), set to OFF.
SCSI ID setting (Factory Default: 4)
SCSI IDs are a number identifying each SCSI unit. Consequently, SCSI IDs must be
set so that no two units duplicate each other on the SCSI bus.
• Setting to 0
• Setting to 1
• Setting to 2
• Setting to 3
• Setting to 4