User Guide

Table of Contents

1 Installing the CD-ROM Drive

Before you begin, turn off the system power. Follow the steps below to install

the CD-ROM drive:

1. Remove the cover from your system. Refer to your system user’s manual.

2. Adjust the Master/Slave jumpers on the back of the CD-ROM drive as

necessary. (The factory default of the slave mode normally should not be

changed. Please refer to Section 4 for more information)

3. Insert the CD-ROM drive unit into a free 5.25-inch drive bay. Secure the

CD-ROM drive to the drive bay rails with the mounting screws (included in

the CD-ROM package). Refer to your system manual for instructions on

how to install a drive.

4. Plug a free power connector inside your PC into the Power socket on the

back of the CD-ROM drive.

5. Plug a free IDE connector inside your PC into the drive’s IDE interface

socket.

NOTE: The red edge of the IDE cable corresponds to pin 1 of the IDE

interface on the CD-ROM drive.

If you have a sound card, you can also connect a 4-pin analog audio

cable to the analog audio-out connector of your CD-ROM drive and the

audio-in connector of the sound card.

If you have a digital audio device, you can also connect a 2-pin digital

audio cable to the digital audio-out connector of your CD-ROM drive and

the audio-in connector of your digital audio device.

6. Replace the cover and turn on the power.

Power Cable

Audio Cable

IDE Cable

Red Strip