Specifications

AWARD BIOS
3-32
Integrated Peripherals Onboard UART 1
Integrated Peripherals Onboard UART 2
Onboard UART 1
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
This item allow you to assign address and interrupt
for the board serial port. Default is Auto.
Note: If you are using an network card, make
sure that the interrupt does not conflict.
Integrated Peripherals Onboard UART 2 Mode
Onboard UART 2
Mode
Standard
HPSIR
ASKIR
This item is configurable only if the " Onboard
UART 2" is enabled. This allows you to specify
the mode of serial port2. The available mode
selections are:
• Standard - Sets serial port 2 to operate in normal mode. This is
the default setting.
• HPSIR - Select this setting if you installed an Infrared module in
your system via IrDA connector (refer to section 2.3 "Connectors"). This
setting allows infrared serial communication at a maximum baud rate of
115K baud.
• ASKIR - Select this setting if you installed an Infrared module via
IrDA connector (refer to section 2.32.3 "Connectors "). This setting
allows infrared serial communication at a maximum baud rate of 19.2K
baud.