User Guide

ManualsBrandsAOpen ManualsOtherAX5T-ORG

AX5T

User's Guide

Printed in Taiwan

PART NO.:49.87801.121

DOC. NO.:AX5T-3-E9708H

Summary of content (12 pages)

PAGE 1
AX5T User's Guide Printed in Taiwan PART NO.:49.87801.121 DOC. NO.
PAGE 2
PAGE 3
AX5T Mainboard User's Guide Document Number : AX5T-3-E9708H Model and Revision : For AX5T revision 3.xx Manual Version : English, version H Release Date : August 19, 1997 More help for latest information: Taiwan http://www.aopen.com.tw USA http://www.aopen-usa.com Europe http://www.aopen.
PAGE 4
Copyright Copyright  1997 by this company. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, manual or otherwise, without the prior written permission of this company.
PAGE 5
Disclaimer This company makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties, merchantability or fitness for any particular purpose. Any software described in this manual is sold or licensed "as is".
PAGE 6
FCC Class B Radio Frequency Declaration of Conformity This equipment has been tested and found to comply with the limits for a Class B Subassembly -CPU Board device, pursuant to Part 15 of FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.
PAGE 7
Notice 1: The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Notice 2: Shielded interface cables, if any, must be used in order to comply with emission limits.
PAGE 8
Purpose and Scope This manual tells how to install and configure the system board. Organization Chapter 1, Overview, covers the introduction and specifications of the system board. Chapter 2, Hardware Installation, describes hardware jumpers, connectors and memory configuration. There are user friendly drawings to locate jumper and connector. Chapter 3, AWARD BIOS, explains the system BIOS and tells how to configure the system by setting the BIOS parameters.
PAGE 9
Conventions The following conventions are used in this manual: Text entered by user, default settings, recommended selections Represent text input by the user, default settings and recommended selections , ,, , , etc Represent the actual keys that you have to press on the keyboard. , Note: Gives bits and pieces of additional information related to the current topic. Warning: Alerts you to any damage that might result from doing or not doing specific actions.
PAGE 10
CONTENTS CHAPTER 1 1.1 1.2 1.3 1.4 1.5 1.6 OVERVIEW SPECIFICATIONS ............................................................ 1-3 SUSPEND TO HARD DRIVE .............................................. 1-5 MODEM WAKE UP .......................................................... 1-8 SYSTEM VOLTAGE MONITORING ................................... 1-10 CPU FAN MONITORING ................................................ 1-11 CPU THERMAL PROTECTION........................................
PAGE 11
3.2 3.3 3.4 3.5 3.6 3.7 3.8 3.9 3.10 3.11 3.12 3.13 3.14 3.15 STANDARD CMOS SETUP .............................................. 3-2 BIOS FEATURES SETUP ................................................ 3-6 CHIPSET FEATURES SETUP .......................................... 3-12 POWER MANAGEMENT SETUP ...................................... 3-18 PNP/PCI CONFIGURATION SETUP ................................ 3-25 LOAD SETUP DEFAULT ................................................. 3-28 LOAD TURBO DEFAULT ........
PAGE 12
4.4 ACCESORY BRACKET AND CABLES................................. 4-6 4.4.1...................................... ATX Power Cable..............................4-7 4.4.2.......................................USB Bracket......................................4-7 4.4.3....................................... Floppy Cable.....................................4-8 4.4.4...................................... IDE Cables for HDD and CDROM.....4-8 4.4.5Front-panel Switch and LED Cables....................................