User Guide

Hardware Installation
2-22
Other housings may have a 12-pin
connector. If your housing has this
type of connector, connect it to
CN15 as shown in the figure. Make
sure that the red wire of the
connector connects to pin 11.
( Turbo Switch )
Break Switch
Ground
VCC
Ground
Ground
Keylock
Reset
Res-VCC
Speaker
Break Switch
The break switch allows you to manually set the system to suspend mode by
simply pressing the switch. However, this is possible only if the Power
Management function in the BIOS Setup menu is enabled. Refer to section
3.2.4 for more information.
If your housing comes with Turbo switch and Turbo
LED connectors, you may use these connectors for
Break switch and Green mode LED functions,
respectively.
Although the Multifunction connector does not support
the Turbo/De-turbo switch, you can still set the system
to Turbo mode by pressing
. To switch to
De-turbo mode, simply press
.