User Guide

Hardware Installation
2-21
2.10.7 Front-panel Switches and LEDs
HDD LED
The HDD LED connector is marked
CN13 on the board. To connect the
HDD LED, simply plug in the LED
cable to this four-pin connector.
Multifunction Connector
The multifunction connector is a 20-
pin connector marked CN15 on the
board. Attach the green mode LED,
keylock, reset switch, break switch,
and green mode LED connectors to
the corresponding pins as shown in
the figure.
( Turbo Switch ) ( Turbo LED )
Break Switch Green Mode LEDReset
Speaker Power LED Keylock
Some housings have a five-pin
connector for the keylock and power
LED.
Speaker Keylock & Power LED
Break Switch Green Mode LED
( Turbo Switch ) ( Turbo LED )
Reset