Service manual

Instrument Functions WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
80Operating Manual 1176.7649.02 ─ 04
Remote command:
CONFigure:BURSt:SPECtrum:FFT[:IMMediate] on page 150
Spectrum ACPR (IEEE 802.11a, ac, g (OFDM Turbo Mode), n, p)/ Spectrum ACP
(IEEE 802.11b)/ ACP Rel/Abs (IEEE 802.11j) ← Spectrum
Sets the ACP (Adjacent Channel Power) result display.
This result display is similar to the Spectrum Mask measurement, and provides infor-
mation about leakage into adjacent channels. The results show the absolute or relative
power measured in the three nearest channels either side of the measured channel.
This measurement is the same as the adjacent channel power measurement provided
by the signal analyzer.
The number of sweeps is set in the General Settings dialog box, Sweep Count field. If
the measurement is performed over multiple sweeps both a max hold trace and an
average trace are displayed.
Softkeys of the WLAN TX Menu