Service manual

Instrument Functions WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
78Operating Manual 1176.7649.02 ─ 04
Fig. 4-2: Spectrum flatness result for IEEE 802.11n (MIMO) with 2 streams
Remote command:
CONFigure:BURSt:SPECtrum:FLATness[:IMMediate] on page 151
IEEE 802.11n (MIMO): CONFigure:BURSt:SPECtrum:FLATness:SELect
on page 151
Spectrum Mask (IEEE 802.11ac, b, g (Single Carrier)) / Spectrum IEEE/ETSI (IEEE
802.11a, g, j, n (OFDM), p) ← Spectrum
Sets the Spectrum Mask result display.
This result display shows power against frequency. The span of the results is 100 MHz
for IEEE and 500 MHz for ETSI around the specified measurement frequency. A limit
line representing the spectrum mask specified for the selected standard is displayed
and an overall pass/fail status is displayed for the obtained results against this limit
line.
The number of sweeps is set in the General Settings dialog box, Sweep Count field. If
the measurement is performed over multiple sweeps both a max hold trace and an
average trace are displayed.
Softkeys of the WLAN TX Menu