Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
224Operating Manual 1176.7649.02 ─ 04
5.19.1 STATus:OPERation Register......................................................................................224
5.19.2 STATus:QUEStionable Register.................................................................................224
5.19.3 STATus:QUEStionable:LIMit Register........................................................................ 225
5.19.4 STATus:QUEStionable:SYNC Register...................................................................... 226
5.19.5 STATus:QUEStionable:ACPLimit Register................................................................. 227
5.19.1 STATus:OPERation Register
This register contains information on which actions the instrument is executing or
which actions the instrument has executed since the last reading. It can be read using
the commands STATus:OPERation:CONDition or STATus:OPERation[:EVENt]
.
Table 5-5: Meaning of the bits used in the STATus:OPERation register
Bit No. Meaning
0
CALibrating
This bit is set as long as the instrument is performing a calibration.
1 - 3 Not used
4 MEASuring
This bit is set when a measurement is in progress (application-specific).
5 - 7 Not used
8 HardCOPy in progress
This bit is set while the instrument is printing a hardcopy.
9 - 14 Not used
15 This bit is always 0.
5.19.2 STATus:QUEStionable Register
This register contains information about indefinite states which may occur if the unit is
operated without meeting the specifications. It can be read using the commands
STATus:QUEStionable:CONDition or STATus:QUEStionable[:EVENt]?.
Table 5-6: Meaning of the bits used in the STATus:QUEStionable register
Bit No. Meaning
0 to 2 These bits are not used
3 POWer
This bit is set if a questionable power occurs (see STATus:QUEStionable:POWer register in
the base unit description).
4 TEMPerature
This bit is set if a questionable temperature occurs.
Status Reporting System (Option R&S FSV-K91)