Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
207Operating Manual 1176.7649.02 ─ 04
Usage: Query only
SCPI confirmed
Mode: WLAN
STATus:QUEStionable:ACPLimit:ENABle
STATus:QUEStionable:LIMit<Screen>:ENABle
STATus:QUEStionable:SYNC:ENABle? <Filter>
Determines whether the EVENt bit of the associated status register contributes to the
sum bit of the STATus:QUEStionable register. Each bit of the EVENt part is
"ANDed" with the associated ENABle bit. The results of all logical operations of this
part are passed on to the event sum bit via an "OR" function.
Suffix:
<Screen>
.
1 | 2
1 = Screen A, 2 = Screen B
Note that limit lines are not displayed in screen A, thus
STAT:QUES:LIM1:ENAB is irrelevant.
Parameters:
<Filter> The sum of the decimal values of the event bits that are to be
enabled for the summmary bit.
Range: 0 to 65535
Usage: Query only
SCPI confirmed
Mode: WLAN
STATus:QUEStionable:ACPLimit:NTRansition
STATus:QUEStionable:LIMit<Screen>:NTRansition
STATus:QUEStionable:SYNC:NTRansition? <Filter>
This bit acts as a transition filter. When a bit of the CONDition part of the associated
status register for the result type is changed from 1 to 0, the NTR bit decides whether
the EVENt bit is set to 1.
Suffix:
<Screen>
.
1 | 2
1 = Screen A, 2 = Screen B
Note that limit lines are not displayed in screen A, thus
STAT:QUES:LIM1:NTR is irrelevant.
Parameters:
<Filter> The sum of the decimal values of the event bits that are to be
enabled.
Range: 0 to 65535
Example:
STAT:QUES:LIM:NTR 65535
All condition bits will be summarized in the Event register when
a negative transition occurs.
STATus Subsystem (WLAN)