Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
206Operating Manual 1176.7649.02 ─ 04
STATus:QUEStionable[:EVENt]?
This command queries the contents of the EVENt part of the STATus:QUEStionable
register. The EVENt part indicates whether an event has occurred since the last read-
ing, it is the "memory" of the condition part. It only indicates events passed on by the
transition filters. It is permanently updated by the instrument. This part can only be
read by the user. Reading the register clears it.
Example:
STAT:QUES?
Usage: Query only
Mode: all
STATus:
QUEStionable:ACPLimit[:EVENt]
STATus:QUEStionable:LIMit<Screen>[:EVENt]
STATus:QUEStionable:SYNC[:EVENt]?
The EVENt part indicates whether an event has occurred since the last reading. It only
indicates events passed on by the transition filters. It is permanently updated by the
instrument. This part can only be read by the user. Reading the register clears it.
Possible events are described in:
chapter 5.19.5, "STATus:QUEStionable:ACPLimit Register", on page 227
chapter 5.19.3, "STATus:QUEStionable:LIMit Register", on page 225
chapter 5.19.4, "STATus:QUEStionable:SYNC Register", on page 226
Suffix:
<Screen>
.
1 | 2
1 = Screen A, 2 = Screen B
Note that limit lines are not displayed in screen A, thus
STAT:QUES:LIM1? always returns 0.
Usage: Query only
SCPI confirmed
Mode: WLAN
STATus:QUEStionable:ACPLimit:CONDition
STATus:QUEStionable:LIMit<Screen>:CONDition
STATus:QUEStionable:SYNC:CONDition?
Contains the current status of the instrument. This register part can only be read, but
not written into or cleared. Readout does not delete the contents of the CONDition sec-
tion.
Suffix:
<Screen>
.
1 | 2
1 = Screen A, 2 = Screen B
Note that limit lines are not displayed in screen A, thus
STAT:QUES:LIM1:COND? always returns 0.
STATus Subsystem (WLAN)