Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
205Operating Manual 1176.7649.02 ─ 04
STATus:QUEStionable[:EVENt]?.....................................................................................206
STATus:QUEStionable:ACPLimit[:EVENt]........................................................................ 206
STATus:QUEStionable:LIMit<Screen>[:EVENt].................................................................206
STATus:QUEStionable:SYNC[:EVENt]?...........................................................................206
STATus:QUEStionable:ACPLimit:CONDition.................................................................... 206
STATus:QUEStionable:LIMit<Screen>:CONDition.............................................................206
STATus:QUEStionable:SYNC:CONDition?.......................................................................206
STATus:QUEStionable:ACPLimit:ENABle........................................................................ 207
STATus:QUEStionable:LIMit<Screen>:ENABle.................................................................207
STATus:QUEStionable:SYNC:ENABle?........................................................................... 207
STATus:QUEStionable:ACPLimit:NTRansition..................................................................207
STATus:QUEStionable:LIMit<Screen>:NTRansition.......................................................... 207
STATus:QUEStionable:SYNC:NTRansition?.....................................................................207
STATus:QUEStionable:ACPLimit:PTRansition.................................................................. 208
STATus:QUEStionable:LIMit<Screen>:PTRansition...........................................................208
STATus:QUEStionable:SYNC:PTRansition?.....................................................................208
STATus:OPERation:CONDition
This command queries the CONDition part of the STATus:OPERation register (see
the base unit description of status registers in the Remote Control Basics chapter).
Readout does not delete the contents of the CONDition part. The value returned
reflects the current hardware status.
Example:
STAT:OPER:COND?
Mode: all
STATus:OPERation[:EVENt]
This command queries the contents of the EVENt part of the STATus:OPERation reg-
ister. The contents of the EVENt part are deleted after readout.
Example:
STAT:OPER?
Mode: all
STATus:QUEStionable:CONDition
This command queries the CONDition part of the "STATus:QUEStionable" register.
This part contains the sum bit of the next lower register. This register part can only be
read, but not written into or cleared. Readout does not delete the contents of the CON-
Dition part.
Example:
STAT:QUES:COND?
Mode: all
STATus Subsystem (WLAN)