Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
204Operating Manual 1176.7649.02 ─ 04
Parameters:
<State> ON | OFF
*RST: ON
Example:
TRAC:PHAS ON
Specifies that the measurement results should be compensated
for phase.
Mode: WLAN
Manual operation: See "Phase" on page 102
[SENSe:]TRACking:PILots <Mode>
This command configures how the pilots of the signal is determined.
Parameters:
<Mode> STANdard
The pilot of the signal is determined as defined by the standard.
DETected
The pilot is detected by estimation; useful when the signal devi-
ates from the standard
*RST: STANdard
Mode: WLAN (IEEE 802.11ac/n (MIMO))
Manual operation: See "Pilots for Tracking (IEEE 802.11n, ac (SISO+MIMO))"
on page 103
[SENSe:]TRACking:TIME <State>
This command defines whether or not the measurement results should be compensa-
ted for time.
Parameters:
<State> ON | OFF
Mode: WLAN
Manual operation: See "Timing" on page 102
5.15 STATus Subsystem (WLAN)
The following commands can be used to query the contents of the status registers spe-
cific to the R&S FSV-K91 option. For details see chapter 5.19, "Status Reporting Sys-
tem (Option R&S FSV-K91)", on page 221.
For details on general status register commands, see the base unit description.
STATus:OPERation:CONDition....................................................................................... 205
STATus:OPERation[:EVENt]...........................................................................................205
STATus:QUEStionable:CONDition...................................................................................205
STATus Subsystem (WLAN)