Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
203Operating Manual 1176.7649.02 ─ 04
[SENSe:]SWEep:TIME <Time>
This command defines the sweep time.
The range depends on the frequency span.
Parameters:
<Time> refer to data sheet
*RST: (automatic)
Example:
SWE:TIME 10s
Manual operation: See "Capture Time " on page 89
[SENSe:]SWEep:EGATe:TYPE <Mode>
This command sets the type of triggering (level or edge) by the external gate signal.
The gate opening time cannot be defined with the command [SENSe:]SWEep:
EGATe:LENGth[:TIME] if level triggering is used. The gate is closed when the gate
signal disappears.
Parameters:
<Mode> LEVel | EDGE
*RST: EDGE
Example:
SWE:EGAT:TYPE EDGE
Sets the gate mode to EDGE.
Mode: WLAN
[SENSe:]TRACking:LEVel <State>
This command defines whether or not the measurement results should be compensa-
ted for level.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
TRAC:LEV ON
Specifies that the measurement results should be compensated
for level.
Mode: WLAN
Manual operation: See "Level" on page 103
[SENSe:]TRACking:PHASe <State>
This command defines whether or not the measurement results should be compensa-
ted for phase.
SENSe Subsystem (WLAN)