Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
202Operating Manual 1176.7649.02 ─ 04
Parameters:
<NumberSamples> *RST: 2000
Example:
SWE:EGAT:HOLD:SAMP 2500
Sets a delay of 2500 samples in the capture buffer.
Mode: WLAN
[SENSe:]SWEep:EGATe:LENGth[:TIME] <Time>
This command defines the gate time in the capture buffer in time units. The range of
this value is dependent on the last run measurement.
Parameters:
<Time> *RST: 400μs
Example:
SWE:EGAT:LENG 20ms
Sets a gate length of 20 milliseconds between sweeps.
Mode: WLAN
[SENSe:]SWEep:EGATe:LENGth:SAMPle <NumberSamples>
This command defines the gate time in the capture buffer as a number of samples. The
range of this value is dependent on the last run measurement.
Parameters:
<NumberSamples> *RST: 8000
Example:
SWE:EGAT:LENG:SAMP 200000
Sets a gate length of 200000 samples in the capture buffer.
Mode: WLAN
[SENSe:]SWEep:EGATe:LINK <State>
This command links together the movement of the gating lines and the capture buffer
marker.
Parameters:
<State> ON | OFF
*RST: 0
Example:
SWE:EGAT:LINK ON
Links the gating lines as marker with the gating line delay and
length are changed gate position.
Mode: WLAN
Manual operation: See "Gating Settings On/Off ((IEEE 802.11a, b, g, j, p)"
on page 67
SENSe Subsystem (WLAN)