Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
195Operating Manual 1176.7649.02 ─ 04
Parameters:
<Analysis> FBURst
The MCS index of the first burst is detected and subsequent
bursts are analyzed only if they have the same MCS index
ALL
All valid bursts are analyzed according to their individual MCS
indexes
MEASure
Only bursts with an MCS index which matches that supplied by
SENSe:]DEMod:FORMat:MCSIndex will be analyzed
DEMod
All bursts will be anayzed according to the MCS index specified
by [SENSe:]DEMod:FORMat:MCSIndex on page 194.
*RST:
FBURst
Example:
SENS:DEM:FORM:MCSI:MOD ALL
selects MCS-Index 1 (BPSK 1 spatial stream)
Mode: WLAN
Manual operation: See "MCS Index to use" on page 105
[SENSe:]DEMod:FORMat:NSTSindex <Index>
Defines the the PPDUs taking part in the analysis depending on their Nsts.
This command is only available for the IEEE 802.11 ac standard.
This command is available for DEM:FORM:NSTS:MODE MEAS or
DEM:FORM:NSTS:MODE DEM (see [SENSe:]DEMod:FORMat:NSTSindex:MODE
on page 195).
Parameters:
<Index>
Example:
SENS:DEM:FORM:NSTS:MODE MEAS
SENS:DEM:FORM:NSTS 1
Manual operation: See "Nsts (IEEE 802.11ac only)" on page 106
[SENSe:]DEMod:FORMat:NSTSindex:MODE <Mode>
Defines the the PPDUs taking part in the analysis depending on their Nsts.
This command is only available for the IEEE 802.11 ac standard.
SENSe Subsystem (WLAN)