Service manual

Remote Commands for WLAN TX Measurements

R&S

FSV-K91/91n/91ac/91p

194Operating Manual 1176.7649.02 ─ 04

[SENSe:]DEMod:FORMat:BTRate <BitRate>

The remote control command is used to specify the bit rate for IEEE 802.11b signals.

This command can be used as an alternative to [SENSe:]DEMod:FORMat:

BANalyze on page 187. The bit rate can be set as follows:

Parameters:

<BitRate> 10 | 20 | 55 | 110

1 Mbit/s

2 Mbit/s

5.5 Mbit/s

110

11 Mbit/s

*RST: 10 (= 1mbit)

Example:

DEM:FORM:BTR 20

Configures to demodulate 2 Mbit/s signals

Mode: WLAN

[SENSe:]DEMod:FORMat:MCSIndex <Index>

This command accesses the MCS-Index which controls the rate and modulation and

streams. It is used as the offset in the available options as shown on control or MCS

parameter tables (see document: IEEE P802.11n/D11.0 June 2009).

Parameters:

<Index> numeric value

*RST: 1

Example:

SENS:DEM:FORM:MCSI 1

selects MCS-Index 1 (BPSK 1 spatial stream)

Mode: WLAN

Manual operation: See "MCS Index" on page 106

[SENSe:]DEMod:FORMat:MCSIndex:MODE <Analysis>

This remote control command specifies how bursts are analyzed acoording to the MCS

index

SENSe Subsystem (WLAN)