Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
193Operating Manual 1176.7649.02 ─ 04
Example:
DEM:FORM:BAN:SYM:MAX 1300
Only bursts which contain a maximum symbol count of 1300 are
analyzed.
Mode: WLAN
Manual operation: See "Max Data Symbols (IEEE 802.11a, ac, j, n, p)"
on page 101
[SENSe:]DEMod:FORMat:BANalyze:SYMBols:MIN <NumberDataSymbols>
This command specifies the number of data symbols required for bursts to qualify for
measurement analysis. Only bursts with the specified number of symbols will be used
in the measurement analysis. The number of data symbols is defined as the uncoded
bits including service and tail bits.
When the [SENSe:]DEMod:FORMat:BANalyze:SYMBols:EQUal command has
been set to true then this command specifies the exact number of symbols required for
a burst to take part in measurement analysis. When the [SENSe:]DEMod:FORMat:
BANalyze:SYMBols:EQUal command is set to false this command specifies the min-
imum number of symbols required for a burst to take part in measurement analysis.
Parameters:
<NumberDataSymbols>*RST: 1
Example:
DEM:FORM:BAN:SYM:MIN 16
Only bursts which contain a symbol count of 16 are analyzed.
Mode: WLAN
Manual operation: See "Data Symbols (IEEE 802.11a, ac, j, n, p)" on page 101
See "Min Data Symbols (IEEE 802.11a, ac, j, n, p)" on page 101
[SENSe:]DEMod:FORMat[:BCONtent]:AUTO <State>
When this command is set to ON, the signal symbol field, resp. the PLCP header field
of the burst is analyzed to determine the details of the burst. When this field is set to
ON, only bursts that match the supplied burst type and modulation are considered in
results analysis.
Parameters:
<State> ON | OFF
Example:
DEM:FORM:AUTO ON
Specifies that the signal symbol field should be decoded.
Mode: WLAN
Manual operation: See "Demod Settings (IEEE 802.ac, n (MIMO) only)" on page 98
See "Auto Demodulation (IEEE 802.11n, SISO)" on page 99
SENSe Subsystem (WLAN)