Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
192Operating Manual 1176.7649.02 ─ 04
If the [SENSe:]DEMod:FORMat:BANalyze:DURation:EQUal on page 191 com-
mand has been set to true then this command specifies the exact duration required for
a burst to take part in measurement analysis.
If the [SENSe:]DEMod:FORMat:BANalyze:DBYTes:EQUal on page 189 command
is set to false this command specifies the minimum duration required for a burst to take
part in measurement analysis.
Parameters:
<Duration> *RST: 1
Example:
DEM:BAN:DUR:MIN 45
Only bursts which last 48 microseconds are analyzed.
Mode: WLAN
Manual operation: See "Payload Length (IEEE 802.11b, g)" on page 102
See "Min Payload Length (IEEE 802.11b, g)" on page 102
[SENSe:]DEMod:FORMat:BANalyze:SYMBols:EQUal <State>
When this command is activated then only bursts of equal length will take part in the
measurement analysis. When this command is set to true the value specified by the
[SENSe:]DEMod:FORMat:BANalyze:SYMBols:EQUal on page 192 command
specifies the number of symbols that a burst must have in order to take part in analy-
sis.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
DEM:FORM:BAN:SYM:EQU ON
Only bursts of equal length will take part in analysis.
Mode: WLAN
Manual operation: See "Equal PPDU Length" on page 100
[SENSe:]DEMod:FORMat:BANalyze:SYMBols:MAX <NumberDataSymbols>
This command specifies the maximum number of data symbols required for bursts to
qualify for measurement analysis. Only bursts with the specified number of symbols
will be used in the measurement analysis. The number of data symbols is defined as
the uncoded bits including service and tail bits.
This value will not have any immediate effect if the [SENSe:]DEMod:FORMat:
BANalyze:SYMBols:EQUal command has been set to true as in this case no range
of symbols is allowed and only bursts with exactly the number of symbols specified by
the [SENSe:]DEMod:FORMat:BANalyze:SYMBols:MIN command shall take place
in measurement analysis.
Parameters:
<NumberDataSymbols>*RST: 64
SENSe Subsystem (WLAN)