Service manual

Remote Commands for WLAN TX Measurements
R&S
®
FSV-K91/91n/91ac/91p
191Operating Manual 1176.7649.02 ─ 04
Mode: WLAN
Manual operation: See "Payload Length (IEEE 802.11b, g)" on page 102
See "Min Payload Length (IEEE 802.11b, g)" on page 102
[SENSe:]DEMod:FORMat:BANalyze:DURation:EQUal <State>
When this command is set to ON then only bursts of equal length will take part in the
PVT analysis. When this command is set to true the value specified by the [SENSe:
]DEMod:FORMat:BANalyze:DURation:MIN on page 191 command specifies the
duration that a burst must last in order to take part in measurement analysis.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
DEM:BAN:DUR:EQU ON
Only bursts of equal length will take part in the measurement
analysis.
Mode: WLAN
Manual operation: See "Equal PPDU Length" on page 100
[SENSe:]DEMod:FORMat:BANalyze:DURation:MAX <Duration>
This command specifies the maximum duration in microseconds required for bursts to
qualify for measurement analysis. Only bursts with the specified duration will be used
in the measurement analysis.
This value will not have any immediate effect if the [SENSe:]DEMod:FORMat:
BANalyze:DURation:EQUal on page 191 command has been set to true as in this
case no range of durations is allowed and only bursts with exactly the duration speci-
fied by the [SENSe:]DEMod:FORMat:BANalyze:DURation:MIN on page 191
command shall take part in measurement analysis
Parameters:
<Duration> *RST: 5464
Example:
DEM:BAN:DUR:MAX 1300
Only bursts which have a maximum duration of 1300 microsec-
onds are analyzed.
Mode: WLAN
Manual operation: See "Max Payload Length (IEEE 802.11b, g)" on page 102
[SENSe:]DEMod:FORMat:BANalyze:DURation:MIN <Duration>
This command specifies the duration in microseconds required for bursts to qualify for
measurement analysis. Only bursts with the specified duration will be used in the mea-
surement analysis.
SENSe Subsystem (WLAN)